From the perspective of improving the uniformity of mold cavity temperature distribution, the area of the mold base wear plate is reduced, such as the shape of the wear plate is changed from trapezoidal to rectangular, so that the overall temperature of the pattern block is increased and the temperature uniformity of the cavity is better; the width of the middle mold sleeve wear plate is reduced, and the overall temperature of the mold cavity is reduced, and the uniformity of the temperature of the pattern block in the mold cavity is improved.
To avoid the problem of rubber hair on the tire surface, two aspects can be considered: one is to improve the mold pore sleeve structure; the other is to change the mold exhaust method. The pore sleeve structure is replaced by a spring pore sleeve from an ordinary pore sleeve. Its working principle is that under the action of the spring, the gas in the cavity is discharged from the gap between the shaft core and the sleeve. After the air is discharged, the rubber is pressed against the shaft core and exerts pressure on the shaft core, thereby avoiding rubber overflow. There are two types of pore sleeve structures.
Changing the exhaust method of the mold is to change the pore exhaust to air line exhaust. Change the structure of the pattern block: First, change the pattern block to a layered type, and the dividing line between the layers is divided according to the pattern pitch. The gas between the rubber and the mold is discharged through the small gap between the layers. Due to the small size of the gap, no obvious rubber edge will be produced on the tire surface, thus replacing the venting of the pores; second, a rib base is processed on the main body of the pattern block. After the rib body is processed separately, it is fixed on the rib base by screws. The gas is discharged through the gap between the rib and the base, avoiding the use of pores for exhaust, and solving the rubber hair problem of the vulcanized tire.
From the aspect of improving the rubber edge and staggered pattern of the tire appearance, with the deformation and wear of the mold parts, there will be overflow of glue between the two pattern block facades, and rubber edges will appear on the tire. The pattern block parting surface is changed from equal division to a combination of large and small alternating. There are two types of angle differences between large and small pattern blocks, 6° and 6.5°, which makes the mold less stressed and deformed at the parting of large and small pattern blocks, improving the rubber edge and staggered pattern problems of the tire. After the mold structure is optimized, it is generally necessary to perform stress and strain verification on the optimized structure to check whether the deformation and stress meet the use requirements. If not, continue to improve the structure. If it does, it is also necessary to consider whether the mold structure is easy to process and whether the existing processing conditions can meet the accuracy requirements. Finally, the effect of the structural improvement must be tested through on-site use.
